Bildiri & Sunum Koleksiyonu
Güncel Gönderiler
-
The controllable deposition of large area roll-to-roll sputtered ito thin films for photovoltaic applications
(Pergamon-Elsevier Science, 2020)In the present study, using a large area roll-to-roll DC magnetron sputtering system deposition of ITO thin films on polyethylene terephthalate (PET) substrates were achieved. In order to investigate the effect of growth ... -
Micro-abrasion wear behavior of thermal-spray-coated steel tooth drill bits
(Polish Academy of Sciences, 2016)Wear behavior of four kinds of thermally sprayed coatings on steel tooth drill bits have been investigated by micro-abrasion wear test. The fixed ball micro abrasion wear test was applied for bare substrate and for thermal ... -
Determination of natural line widths of Kα X-ray lines for some elements in the atomic range 50≤Z≤65 at 59.5 keV
(American Institute of Physics Inc., 2017)The semi-empirical determination of natural widths of K alpha X-ray lines (K alpha 1 and K alpha 2) were performed for Si), Sb, Te, I, Ba, La, Ce, Pr, Nd, Sm, Eu, Gd and Tb. For the semi-empirical determination of the line ... -
The Ratios of Emission Probabilities of Auger electrons for 3d Transition elements at 59,5 keV
(American Institute of Physics Inc., 2017)The ratios of emission probabilities were determined by using the measured K shell X-ray intensity ratio values for elements from Sc to Zn. For the experimental measurements, the samples were excited by 59.5 keV gamma rays ... -
Empirical K-Shell Production Cross Sections Induced by 2-5 MeV Alpha on Elements of Z= 25 to 30
(American Institute of Physics Inc., 2018)During the last decades, the study of phenomena occurring in collisions between charged particles and target atoms has grown to a field of increasing interest in both its theoretical and experimental aspects. This growing ... -
Effects of blanking speed on the shear surface of mild steel (St37)
(Polish Academy of Sciences, 2016)Blanking operation is widely used to cut sheet or plates by a shearing process between punch and die. The process of shearing and the conditions of the sheared surface are influenced by the punch, the die, the speed of ...
RSS 1.0
